First mountain climbing ideas.

After some consideration, we narrowed down our drive system options to 3 different ways our robot could climb the1Y7A1592 mountain.

Our first idea was a simple four wheel tank with treads attached to its side. This would be combined with a linear slide that would hook on to the highest or second highest bar, assisting the climb.

Our second idea was based off the first, except the robot could come off its wheels. In other words, the body of the robot could remain horizontal to the ground while the wheels tilted to drive up the ramp.

Our third idea was a stair climber. In this design the drive is a simple tank drive. What allows the robot to scale the mountain are two hooks that go in a circular motion in front of the wheels. They hook onto each bar and lift the robot over them.

We are now prototyping our designs and drawing them up in Creo.

-IT 10/10/15

Advertisements

Launching Our New Season at the Res-Q Kickoff!

We had a blast attending this season’s kickoff at Needham High School on September 12! We partook in various sessions about key FTC components such as the new drive system and PTC Creo. We also helped lead sessions about judging and the engineering notebook. This year’s challenge was also revealed at the kickoff. It includes a ‘mountain’ with bars across it that the robot must climb and ball and blocks that the robot must deliver into buckets.

After the event finished, we were buzzing with ideas. We stopped for an all team Chipotle lunch before heading home for a meeting, where we brainstormed drive systems to accommodate climbing the mountain, ball and block pickup/delivery designs, and robot lifting designs. Irene drew a great summary of our initial ideas below.

FullSizeRender

We’re so excited for the season and can’t wait to get started.

-AS 10/10/2015